1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules

JRK setup guide @eaorobbie

Refer to Eaorobbie's post here for step by step startup :)

For a 2DOF, you need 2 JRK 12v12 boards. Each JRK drives its own actuator
  • JRK1 connected to COM4
  • SimTools "interface 1" sends the information for axis 1 to COM4
  • JRK1 sends commands of axis 1 to actuator 1.
  • JRK2 connected to COM6
  • SimTools "interface 2" sends the information for axis 2 to COM6
  • JRK2 sends commands of axis 2 to actuator 2.
[​IMG]

from eaorobbie:
jrk wiring.jpg

How I wire a dc car battery, beware the rocker switches (red ones) have an internal led in them so the earth (gnd) connect is not needed if using ones that don't have a led in them.[
car battery.jpg
Category:
JRK
Published:
May 25, 2014
Page Views:
7751