Diy 3Dof inspired by the SK1 simukit

After 5 years of good and loyal service of my 2 Dof, it is following the purchase of a 3 dofs kit that I decide to redo a new simulation.

This is the kit:

I started to draw my project in order to prepare the necessary material and redo the parts damaged by the previous owner

Here, I finished my plans.
The location and length of the connecting rods are defined

As I indicated, I bought a second-hand kit, the cogwheels being damaged, I modeled and printed new wheels.

elders



News

Preparation of engine and cam supports.

The project is progressing slowly!

Updated construction.
for aesthetic reasons, I painted the power supplies

And a structure cut out of plexiglass to hold it all!

Finished the mobile part!

A small logo on 8mn plexiglass to reinforce and decorate

Anti-twist bars, connecting rods and seat installed

First test this afternoon. The simulation works well.
For the settings, I find it difficult to understand the tunning center, because if, as indicated, I do a few laps by activating the max and min capture then by saving, my effects are almost zero then ...

Yes, I saved well before stopping the capture.
I'll relaunch the game and send you the pictures.
thank you very much for your help

Hello, here are the screenshots:

The game is tasteless ... there are a few small movements in the acceleration and braking, but the heave for example is imperceptible

Try this. Don't do a few laps, just drive a little way, don't hit anything or go off the road, and don't go real fast. Turn the wheel right and left a few times and brake and accelerate moderately. Then save. After some time experimenting and adjusting how you drive when tuning you will figure out what works best for you. You still need to fine tune the numbers manually though for best results.