1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

SimLab GT2 to 2DOF conversion.

Discussion in 'DIY Motion Simulator Projects' started by iLLuac4, Nov 8, 2019.

Tags:
Page 3 of 3
  1. BloxofCode

    BloxofCode New Member

    Joined:
    Aug 27, 2021
    Messages:
    20
    Balance:
    84Coins
    Ratings:
    +2 / 0 / -0
    My Motion Simulator:
    2DOF, SCN5, SCN6, Arduino
    Its OK Sir...I Just wanted to print for some 3D prints testing.:).

    By the way Sir do you hole a screw on the big pulley one?
    BloxofCode, Sep 23, 2021
    #41
  2. iLLuac4

    iLLuac4 Active Member

    Joined:
    Jun 19, 2019
    Messages:
    130
    Balance:
    884Coins
    Ratings:
    +54 / 0 / -0
    My Motion Simulator:
    2DOF
    I do not know what do you want to know with (do you hole a screw on the big pulley one?) :) Check the picture in previous post it is very clear to see how it was done.
    Last edited: Sep 23, 2021
    iLLuac4, Sep 23, 2021
    #42
  3. BloxofCode

    BloxofCode New Member

    Joined:
    Aug 27, 2021
    Messages:
    20
    Balance:
    84Coins
    Ratings:
    +2 / 0 / -0
    My Motion Simulator:
    2DOF, SCN5, SCN6, Arduino
    Haha..ok Sir I will try to figure it out if lock screw still needed on the big pulley from the motor. I will keep you posted..
    BloxofCode, Sep 23, 2021
    #43
Page 3 of 3