1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Question 2dof seat shaker: motor front or rear?

Discussion in 'DIY Motion Simulator Building Q&A / FAQ' started by dgworks, Oct 15, 2021.

  1. dgworks

    dgworks New Member

    Joined:
    Oct 13, 2021
    Messages:
    12
    Balance:
    - 56Coins
    Ratings:
    +2 / 0 / -0
    Hi I started planning my first motion sim.
    I'm living in a apartment so the compact seat shaker seems a better choice for me.

    During my research I've seen people mounting the motor in the front or rear of the U joint, what are the pros and cons?

    Just ordered one motor (24V 300W 60rpm with 24nm) , potentiometer, power supply and Arduino to see if i can make it work.
    and If motion seat is actually my thing, i might mount my whole setup on the 2dof rack, but sure that will take up a lot of space.
    dgworks, Oct 15, 2021
    #1
  2. noorbeast

    noorbeast VR Tassie Devil Staff Member Moderator Race Director

    Joined:
    Jul 13, 2014
    Messages:
    21,147
    Occupation:
    Innovative tech specialist for NGOs
    Location:
    St Helens, Tasmania, Australia
    Balance:
    148,578Coins
    Ratings:
    +10,903 / 54 / -2
    My Motion Simulator:
    3DOF, DC motor, JRK
    noorbeast, Oct 16, 2021
    #2
  3. dgworks

    dgworks New Member

    Joined:
    Oct 13, 2021
    Messages:
    12
    Balance:
    - 56Coins
    Ratings:
    +2 / 0 / -0
    thanks for the reply, i tried the program before

    Just a strange thing crossing my mind:
    did anyone use pulleys on motion systems? what's the disadvantage of it?
    the pulling spring required on the other side will offset the advantage of it?

    dgworks, Oct 16, 2021
    #3
  4. noorbeast

    noorbeast VR Tassie Devil Staff Member Moderator Race Director

    Joined:
    Jul 13, 2014
    Messages:
    21,147
    Occupation:
    Innovative tech specialist for NGOs
    Location:
    St Helens, Tasmania, Australia
    Balance:
    148,578Coins
    Ratings:
    +10,903 / 54 / -2
    My Motion Simulator:
    3DOF, DC motor, JRK
    noorbeast, Oct 16, 2021
    #4