1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Question How asda-b2 series motors connect motion controllers

Discussion in 'DIY Motion Simulator Projects' started by cong007, Feb 16, 2022.

Tags:
  1. cong007

    cong007 New Member Gold Contributor

    Joined:
    Nov 21, 2021
    Messages:
    22
    Balance:
    - 192Coins
    Ratings:
    +1 / 0 / -0
    hello everyone
    I don't know how to control the operation of the motor through simtools. The motor didn't respond during the test.
    My knowledge is limited, please help me, thank you.

    My mother tongue is not English, so please forgive me.

    Attached Files:

    • 01.jpg
      01.jpg
      File size:
      369.8 KB
      Views:
      176
    • 02.jpg
      02.jpg
      File size:
      233.6 KB
      Views:
      164
    • 03.jpg
      03.jpg
      File size:
      294.4 KB
      Views:
      176
    cong007, Feb 16, 2022
    #1
  2. noorbeast

    noorbeast VR Tassie Devil Staff Member Moderator Race Director

    Joined:
    Jul 13, 2014
    Messages:
    21,152
    Occupation:
    Innovative tech specialist for NGOs
    Location:
    St Helens, Tasmania, Australia
    Balance:
    148,598Coins
    Ratings:
    +10,909 / 54 / -2
    My Motion Simulator:
    3DOF, DC motor, JRK
    How does your hardware communicate? If you can determine that perhaps @yobuddy could advise how to then interface your hardware with SimTools.
    • Agree Agree x 1
    noorbeast, Feb 16, 2022
    #2
  3. cong007

    cong007 New Member Gold Contributor

    Joined:
    Nov 21, 2021
    Messages:
    22
    Balance:
    - 192Coins
    Ratings:
    +1 / 0 / -0
    Thank you very much for your reply

    My PC is connected to the motion control card through the network cable, then connected to the ancestral service driver through the data cable, and then connected to the ancestral service motor. Through the debugging software of the motion controller, the motor operation can be controlled, which shows that there is no problem with the wiring.

    However, set network in simtools and click test, and the motor will not run.

    The motor supports modbus, RS485 & RS232 protocol.

    If you don't connect through COM, how to make simtools output signals through the network? Thank you.
    cong007, Feb 17, 2022
    #3