simulador 2dof arduino inicio

Thanks for the quick response!
I did the tests with the multimeter and has no contact with the motor hull.
I will send photos of my equipment.

have you tried to power on your electronics with no motors connected to see what happens?
if it works ok try connecting one motor at time. if not try another power supply at 12V without motors connected again.

When I turn on the plates only works!
But when you connect the source to the motor does not work.
I have 2 sources of 50A 24V, 4 engines of this that in the photo.
I've only had all the components even the Arduino.
Also changed the H bridge to see what was happening and nothing!
did not fail to test the connected source without running the engine and ran everything, but when I turn on the engines and the SMC3 GameEgine works for about 2 seconds or less and giving the message that something caused the GameEgine stop working !

if i can understand right you are saying that when you turn on your motors power supply with motors disconnected everything works ok and when you connect them, then SMCutils crashes?
have you done what @Pit advised you as @noorbeast said earlier?

Yes that's right!
So I did the tests but the engines are ok!
No contact with the wires in motors (the land is not giving contact in the engine block)[/QUOTE]

Good afternoon staff? @insanegr @bsft
I did the tests with a crush notebook I have and everything works normally!
I'll format my conputador, may be something wrong with the windows7 64bit?

Goodnight everyone?
@noorbeast @bsft
how do I get the platform movements is smooth?
My engines are 24v 250wts Reduction 1/25.
The movements are very sharp especially in NoLimits game.

Ok at a guess you need to tune the Min and Max in the Tuning centre.

thanks for the reply!
is how you give me a hint on how to set the Tuning center?
how do I save? did not quite understand this part!

Skip down to the profile writing part
http://www.xsimulator.net/community...-set-up-simtools-jrks-and-write-profiles.112/

friends has a video showing how to do this?
please.

Good afternoon?
@bsft You could make a video of how to change the tuning center.
Sorry but I'm struggling on how to proceed even reading the manual!
To give you an idea motors are moving so fast that broke my structure!
I tried to reduce the SMC3 in PWMmax and PWMmin, but then the engines do not realize lift the weight! please

@Claudemir you have to raise up the values in the tuning center, meaning you begin with 20 and then reduce step by step.

No I do not have time to do a video, others here have almost explained word for word in different ways. Figure it out.
Thats and yo obviously cannot read, my signature says I do not know arduino. So why the hell are you asking!

@bsft lol, mate cool down. I think sometimes we are too helpful, so some guys do not bother reading the basics. I wonder how to build a sim if someone cannot read the manuals and all the hints given by the very helpful users.

reading the manual is fine, then asking questions about something thats not even on the manual is wrong, especially when I find out they are also getting advice from people whom do not know.
Dont worry @Pit , you are one of the knowledgeable ones

Thank you all for the answers!
I know I can be being inconvenient and annoying.
Also peopl apologize for not knowing how to read or properly understand the manual.
I do not have the same ease of interpreting and understanding the programs as well as many of you, and even adimiro patience who are having me hope that I can finish my project because it is my dream.
I am Brazilian and Brazil does not have the same attitude
Congratulations thank you!

good job