Atomic A2 joyride and SIMTOOLS

read teh doc as outlined, ignore JRK setup part and do each force individually , fiddle with tuning centre numbers. Remember to set each for as a base of 20%

Tried to look it up in a patent database, but could not find anything. Seems they used a different company name.

I think the weigh compensation is simply a sliding table allowing the seat/frame to move back and forth, but the actuators and pivot stay still.
I did this ages ago on a sim using seat rails

In this case, I used it for balance between seat mover and full frame add on, however, it would work the same for adjusting for a heavier to lighter driver
seat mover position

full frame add on position
You can see in the photos where its been moved back.
Atomic do a similar thing

You are correct. You can move the seat fore and aft over the pivot point and actuators to compensate for weight. The A2 has a separate adjustment for seat tilt. Yours is very similar to the A2. Nice job!

Could you tell me what you had to do to get simvibe to work with simtools? I also purchased simvibe a while back and would like to use it on my new rig that i am building.

I did not use Simvibe with SimTools. My motion rig has 2 transducers under the seat aside from the buttkickers. I haven't used SimVibe with SimTools. If I don't have motion with a particular sim, then I use Simvibe.

As for my OP I have since updated my Simphinity (motion software) and now have motion for PCARS and the others I originially didn't have. So I don't use SimTools right now.

Thanks for the info.

I haven't tried it but, there is a setting in SimVibe that allows you to launch your sim/game outside of SimVibe. So try setting up SimVibe with that option but don't close it. Start SimTools and launch the game from there.

Thanks for the reply. I will give it a try when i get my rig finished. thanks again!