k8055

is there a fix when i use two k8055 on one pc i get bad lag on second board

yes...buy 2 jrks instead for motor control, use the K8055 for dashboards :

A jrk is this one. Connecting a jrk to a motor, the software, etc. is easy. There are plenty of threads in the forum for example here.
K8055 are ONLY for pneumatic and hydraulik, they are not usable for electric motors!

thanks for that but my chair works fine with 3 computers wish to go for two for quick and simple starup chair is 4pos. k8055 is great for my setup

It would be interesting to see your set up.
Otherwise , if you ask the question on www.x-sim.de , there may be an answer there.

thanks for that. Been to x-sim.de still new to posting. The site is to hard to workout into hardware not webpagers. I will post all my hardware info when i get the time been working on it 3.5 years now close to end game with this ver #4

K8055s work fine with electric motors - since sirnoname posted that comment about k8055s only being good for pneumatic or hydraulic I have done much experimentation, and fully documented a couple of viable k8055 solutions.

http://www.x-simulator.de/forum/k8055-dual-wiper-motor-control-with-variable-speed-t2795.html

Ok - not as fast as some of the commercial solutions on here, but super cheap and perfectly effective for aircraft sims

Here's one of my test actuators:

http://m.youtube.com/watch?v=if0nzgkNcgk

To directly answer your first question, use a pc per k8055 - known issue ;o)

T

I would advise too only use it in a flight sim situation as its refresh rate causes way too much lag, pc end and game end to be an effective race sim, tested this myself many moons ago.
No there is not a fix, makers wont update the dll for it. Sorry we have asked this from them.