1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

A1M SVD15 Servo driver speed setting locked ??

Discussion in 'Motor actuators and drivers' started by Deane, Nov 21, 2024.

  1. Deane

    Deane Old Fart Gold Contributor

    Joined:
    Aug 25, 2018
    Messages:
    214
    Occupation:
    Retired
    Location:
    Wirrina Cove, South Australia
    Balance:
    685Coins
    Ratings:
    +90 / 3 / -0
    My Motion Simulator:
    2DOF
    I am new to AC servo drives and I am setting them up for a SFX 100 Simfeedback rig, and I have set them up Ok in the initial test session and I went to change the servo's speed from the test speed of 1200 up to the max setting which is 3000.
    Anyhow I did three of the four no problems using P51 command with no problems, but somehow I have pressed a wrong button and it has locked that setting and it does no change after editing the speed, and just reverts to the set 1200.
    I tried powering the drive off and trying again, but no difference .
    So I tried searching online and reading the driver manual etc but I can't work out what I have done.
    I am assuming that I can probably reset the driver to factory settings but worried that I will lose the lot.

    I have the settings written down for the functions that I was setting up etc which were
    P8
    P9
    P51
    P97
    P98
    P109
    P110
    P113
    P114
    P115
    So should I pull the trigger and do a factory reset, or does someone know how the revert whatever I have done.

    Thanks.
    Deane, Nov 21, 2024
    #1
  2. Deane

    Deane Old Fart Gold Contributor

    Joined:
    Aug 25, 2018
    Messages:
    214
    Occupation:
    Retired
    Location:
    Wirrina Cove, South Australia
    Balance:
    685Coins
    Ratings:
    +90 / 3 / -0
    My Motion Simulator:
    2DOF
    Problem solved by doing a factory reset and re-entering the necessary parameters.
    You learn something new every day.
    • Informative Informative x 1
    Deane, Nov 23, 2024
    #2