1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules

Help to setup

Discussion in 'DIY Motion Simulator Projects' started by Deniskappa, Apr 13, 2012.

  1. Deniskappa

    Deniskappa New Member

    Joined:
    Apr 9, 2009
    Messages:
    13
    Balance:
    0Coins
    Ratings:
    +0 / 0 / -0
    Hello everyone. Sorry for my english, I would like your help please. I have two cylinders idraulyc and K8055. Everything works but using the cylinders mode r'n'r. A cylinder for up and down and a cylinder for left / right. I wanted to build a simulator-type cylinders behind (as snc Frex design). You can configure the profiler to run them in this way? Thank you so much! Denis