1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Hexin 232-485 Converter Problems. Help Please

Discussion in 'SimTools compatible interfaces' started by bzdadwith5, Mar 11, 2012.

  1. bzdadwith5

    bzdadwith5 New Member

    Joined:
    Feb 13, 2012
    Messages:
    2
    Balance:
    0Coins
    Ratings:
    +0 / 0 / -0
    I am having problems with my Hexin converter , Yesterday all was working fine and moving my scn6 actuator but today when using it the force profiler came up and said warning an interface was unplugged and then it would no longer detect the scn6's i checked all wires and looked good changed to a new converter and it worked just long enough to detect the actuators and again sent same message, warning an interface was unplugged, and would no longer detect any actuator. this has happened with 3 converters.
    ANY HELP APPRECIATED !!!!
    bzdadwith5, Mar 11, 2012
    #1
  2. speedy

    speedy Well-Known Member

    Joined:
    Feb 1, 2012
    Messages:
    1,193
    Location:
    Alexandria , Egypt
    Balance:
    7,939Coins
    Ratings:
    +1,287 / 10 / -0
    My Motion Simulator:
    3DOF, AC motor, Arduino, Motion platform
    try changing ,uninstall/install ,updating the drivers for the converters ... check them on other computers if they fail there too ... if not ... you have a virus :yes:
    speedy, Mar 12, 2012
    #2