1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Question I'm having trouble running sfx100 using flypt

Discussion in 'DIY Motion Simulator Building Q&A / FAQ' started by xdt5R, Apr 9, 2024.

  1. xdt5R

    xdt5R New Member Gold Contributor

    Joined:
    Feb 28, 2022
    Messages:
    1
    Balance:
    - 4Coins
    Ratings:
    +0 / 0 / -0
    I made an sfx100 using the Thanos amc board.
    I succeeded in moving the motion simulator using flypt, but it works very slowly.
    In flypt, I only did basic rig settings. (I didn't use any filters.) I only applied basic filters to the Thanos board(same when I removed the filter). I also checked the setting on the motor side.
    If you know the solution, I would appreciate it if you could let me know.
    xdt5R, Apr 9, 2024
    #1
  2. pmvcda

    pmvcda aka FlyPT

    Joined:
    Nov 3, 2010
    Messages:
    2,158
    Location:
    Portugal
    Balance:
    15,264Coins
    Ratings:
    +2,530 / 17 / -0
    My Motion Simulator:
    6DOF
    Please share the mover setup to take a look.
    On the thanos board, look at the spike filter. Try to disable, might be to strong.
    Or maybe the setup for the actuators is wrong in thanos board with a high value like 20mm/rpm and it should be 5mm/rpm.
    In mover look at the bit value and gain in the rig module.
    pmvcda, Apr 9, 2024
    #2