1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

petg

Discussion in '3D Printing' started by bruce stephen, Mar 17, 2016.

  1. bruce stephen

    bruce stephen Hammer doesnt fix it, must be electrical

    Joined:
    Jun 7, 2015
    Messages:
    1,286
    Occupation:
    general contractor
    Location:
    michigan
    Balance:
    9,112Coins
    Ratings:
    +1,238 / 9 / -0
    My Motion Simulator:
    2DOF, DC motor, Arduino, Motion platform, 6DOF
    so I picked up some petg from the "micro center". overall i am fairly impressed. it prints easier than abs and doesnt curl like abs. the parts seem a little stronger than abs with a similar flex. the resolution is not as good as abs, although its not even close to being as bad as pla. so far the best resolution imo has been with abs or polycarb. poly is the hardest plastic so far.
    bruce stephen, Mar 17, 2016
    #1
  2. Historiker

    Historiker Dramamine Adict Gold Contributor

    Joined:
    Dec 16, 2010
    Messages:
    2,160
    Occupation:
    Retired
    Location:
    Michigan USA
    Balance:
    9,195Coins
    Ratings:
    +2,161 / 19 / -1
    My Motion Simulator:
    3DOF, DC motor, Arduino, Motion platform, 6DOF
    I like the PETG that I tried, it is strong but does have some flex without breaking, which is good if I were making R/C parts. I thought it made good solid parts compared to the PLA that I have.
    • Like Like x 1
    Historiker, Mar 17, 2016
    #2