Problem with Video Plugin (X-Sim 2.1.0.2)

Hello!
I cannot get the video plugin/editor to work with Profiler2 - it's not receiving slot/axis information from the editor.
here's a brief summary of what's happening:
> force sender with video plugin selected
> video editor opens; video is loaded - no problems on either video screens
> profiler shows force-sender connected - 'input setup' shows slots 25-30 with lateral,vertical, etc
> axis is edited in video editor - video plays back fine, axis graphical data seen
**profiler not showing any slot data at any time - during editing or playback;
the axis result in math setup is also not showing any data
> 'save project' - file fs2 file is created in same directory
> when fs2 file is double clicked it opens in video editor but there is no video or axis data - just blank
another thing noticed was that under 'Config' in video editor it doesn't seem to save the force sender location - if you select set force sender location it's always blank

any ideas on the above?
I've spent many hours re. Wiki/forum/changing settings etc but to no avail and am in need of test running a 3dof pneumatic prototype (video to be posted)

any help would be much appreciated

Best Regards!

Hi All
here's an update on what I've found so far re. this issue (might also help others attempting to work with video plugin):
I uninstalled X-sim 2.1, loaded 1.6 and the video editor 1.5/rollercoaster.exe works fine (although a bit glitchy);
> while editing the axes with the sliders, slot/axis results did not appear in Profiler (slots 21 & 22) but results did appear with playback of the .fsm file
> the videoplugin.rnr that the manual & Wiki refer to appears to be for version 1.6 (and earlier ones I assume) but doesn't appear to apply to 2.0+
> the .fsm file that is created upon 'save project' in 1.6 only likes to playback once and the application closes when the file is finished playing; also, if I try to pause/stop etc while playing, the application closes

so, I'm pretty certain the issue doesn't involve my codecs or windows settings - unless video editor 2.0 is very different than 1.5

not sure where to go from here as video editor 1.5 is only 2 axes and doesn't have advanced output...

has anyone edited axis data in editor 2.0 and played it back via the .fs2 file? (vs importing data)

any ideas would be appreciated :
Best Regards

thank you for looking into this re. the fs2 issue

can anyone direct me to the Video plugin .rn2 simulator profile file?