1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Quick question about g-force 2dof

Discussion in 'New users start here - FAQ' started by Ryuuken29, Sep 13, 2016.

  1. Ryuuken29

    Ryuuken29 New Member

    Joined:
    Jan 20, 2015
    Messages:
    10
    Location:
    Oslo, Norway
    Balance:
    268Coins
    Ratings:
    +1 / 0 / -0
    My Motion Simulator:
    2DOF, DC motor, Arduino, Motion platform
    Hey. My platform mover seems to have lost 2/3 of the total g force when running any sim. It's a 60x60cm2 platform, 40 cm above ground, 2dof, motors are on the back. I have tested it before with a normal table chair on top, which was amazingly terrifying so, I bolted down a seat to the board right in the middle, it's really weak, now.

    Should I move the chair above the rods or raise the chair 50cm up?
    Ryuuken29, Sep 13, 2016
    #1
  2. noorbeast

    noorbeast VR Tassie Devil Staff Member Moderator Race Director

    Joined:
    Jul 13, 2014
    Messages:
    21,398
    Occupation:
    Innovative tech specialist for NGOs
    Location:
    St Helens, Tasmania, Australia
    Balance:
    150,043Coins
    Ratings:
    +10,993 / 54 / -2
    My Motion Simulator:
    3DOF, DC motor, JRK
    Do you have a build thread or photos? It is much easier to give advice if members know what you are actually describing.
    noorbeast, Sep 13, 2016
    #2