1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules

REVISED - "Electronics" Shopping List Suggestions for CKAS

Discussion in 'DIY Motion Simulator Projects' started by cthiggin, Aug 29, 2013.

  1. cthiggin

    cthiggin Active Member

    Joined:
    Jul 1, 2012
    Messages:
    672
    Occupation:
    Self-Employed
    Location:
    Montgomery AL USA
    Balance:
    15,209Coins
    Ratings:
    +435 / 0 / -0
    My Motion Simulator:
    3DOF, AC motor, Arduino, Motion platform
    Hi Folks,
    Been watching this forum and all of the information for quite some time....now, I need your thoughts and help.....
    I'm starting the welding on my frame (pics will follow) for an AC 3DOF CKAS type platform.
    I have all of the steel, u-joint, 3- 1hp AC Motors 230V 3Ph, Boston Gearboxes 60:1 - so my output will be 30 rpm, rods, rod ends etc.

    FIRST: I am a good house electrician, HOWEVER, when it comes to electronics, I'm the typical noobie - Two Wire Hookem Up, Three Wire Screwem Up!

    I know I'll need 3 VFD's, three pots - but it ends there. I've seen at other places the Thanos 1.6 boards, the 6dof boards, heard about Arduino??? -

    WELL, that's the help I need. What is the best route to go for driving this platform??? I do not have a clue, and I have great fear as I mostly read about programming code etc....
    Hopefully, I want to purchase the right electronic hardware, with your help, do the correct wiring, and be done with it.

    Your help and thoughts would be highly appreciated.

    Have a blessed one,

    cthiggin