RocknRide 1.3 - Help 2012

I will start my motion simulator using RnR 1.3 interface.

I bought one board of member yobuddy and now I will try to construct my new simulator, but I have some questions and I need some help...

Questions:
1º RnR 1.3 wokrs with the new software Sim 3.0 in windows seven 64bits????
2º Can I construct the motion simulator left+right movement (like SCN5) or only picth and roll (old project)????

Today this is my simulator - no motion



Thanks.

:hi: Hi welcome, I am very new to give you advice, but if you want to use scn5 then I show this link of a user using these actuators, the insurance can help a lot, that user's work is very good, good luck! :thbup:


simu-with-reduce-for-2-scn5-simxperience-t2774.html?hilit=jolili

Thanks for the info... but i dont have money to buy scn5 system, i will try pneumatic system.... do you have infomation about RnR USB???

Hello, just a suggestion. Have you considered putting your frame on a base with a pivot point under the centre of gravity and then using motors like boat winch motors, 12 volt, and perhaps Pololu JRK boards to control?
You could mount the motors connecting at the rear at shoulder height . You many be surprised how hard the winch motors can move. Just look at Aldoz project. Although with yours, you would not need long levers on the motors, maybe between 60- 100mm long would be more than enough to throw you around.

Yes, to start I will try use a base like you said... I bought a board RnR 1.3, to me is more easy using pneumatic system. Thanks for the information about pololu JRK I will study this information.

Sorry abount my english...

Please, somebody have the profile RnR 1.3 USB to new released - Aluminium edition
3.0.0 beta using two valve and normal speed?????