1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Sabertooth 2x60 motor controller information.

Discussion in 'Motor actuators and drivers' started by 204flightsinmotion, Nov 9, 2025 at 05:10.

  1. 204flightsinmotion

    204flightsinmotion New Member

    Joined:
    Aug 28, 2023
    Messages:
    28
    Balance:
    157Coins
    Ratings:
    +2 / 0 / -0
    I started off my motorcycle sim with 2 ibt2s and one of them was faulty. I ordered the 100A board that the have been talking about on the forum and it came with Chanel b faulty. No luck lol. Ordered a second one which is going to take a few weeks but then decided I was going to go better and ordered the Sabertooth 2x60. Now that it’s on the way looking for any advice on wiring those one. For some reason the diagram I found had less wires going to it than the ibt2 and the 100a board. Also which mode do I set it to in smc arduino code. Any tips and advice appreciated
    204flightsinmotion, Nov 9, 2025 at 05:10
    #1
  2. noorbeast

    noorbeast VR Tassie Devil Staff Member Moderator Race Director

    Joined:
    Jul 13, 2014
    Messages:
    21,815
    Occupation:
    Innovative tech specialist for NGOs
    Location:
    Tasmania, Australia
    Balance:
    152,694Coins
    Ratings:
    +11,091 / 56 / -2
    My Motion Simulator:
    3DOF, DC motor, JRK
    noorbeast, Nov 9, 2025 at 06:24
    #2