1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Question Servo motor calibration issue

Discussion in 'DIY Motion Simulator Building Q&A / FAQ' started by Robdog, Jul 13, 2017.

  1. Robdog

    Robdog Member

    Joined:
    Jul 12, 2015
    Messages:
    51
    Location:
    Newcastle, Australia
    Balance:
    104Coins
    Ratings:
    +56 / 0 / -0
    My Motion Simulator:
    3DOF, JRK
    I have a gseat on my rig powered by servo motors, 2 on each side. I have just upgraded to the new version of Simtools and now the left hand motors don't have full travel anymore. When testing the output I can only move to -21% and +100%, the motors on the right perform correctly with -100% to +100%. Has anyone else come across this problem?
    Robdog, Jul 13, 2017
    #1