1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules

Setting up AMC on xsim

Discussion in 'DIY Motion Simulator Building Q&A / FAQ' started by mattsim25, Mar 27, 2012.

  1. mattsim25

    mattsim25 New Member

    Joined:
    Sep 30, 2011
    Messages:
    18
    Balance:
    2Coins
    Ratings:
    +0 / 0 / -0
    I've been looking for a post I saw a while back about setting up the AMC in xsim. If I remember correctly it explained how to setup the AMC as a controller and use a steering wheel to move rc motors to test. Does anyone know what I'm talking about and know where it's located? I've been searching for the last hour and can not remember where it was. Any help is much appreciated!

    Thanks,

    Matt
  2. mattsim25

    mattsim25 New Member

    Joined:
    Sep 30, 2011
    Messages:
    18
    Balance:
    2Coins
    Ratings:
    +0 / 0 / -0
    Well I think maybe I got part of it to work. I set up the profiler with a joystick input and I can move an axis of the joystick and get the graph on the math setting tab to move but the rc servos I have hooked up don't move. My sting is AB~255~~a01~~a02~. If anyone has any suggestions let me know. I'm going to browse through the main AMC thread.
  3. tronicgr

    tronicgr

    Balance:
    Coins
    Ratings:
    +0 / 0 / -0
    RC servos? no.... The Firmware v1.0 supports only DC motors via H-bridge.

    I removed the RC servos support as there are other RC servo controllers around that do that (pololu for example)