1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Question SimXperience SX4000 issue

Discussion in 'Commercial Simulators and Peripherie' started by Artistichalo, Jun 27, 2020.

  1. Artistichalo

    Artistichalo Member

    Joined:
    Sep 8, 2016
    Messages:
    45
    Location:
    South Florida
    Balance:
    511Coins
    Ratings:
    +1 / 0 / -0
    Good evening my fellow sim racers . I have a Stage 1 Sim Experience motion rig. The control unit is having issues there are four ports for the actuators . Ports 1 and 2 is what you would use for the setup that i have when you first purchase the kit . In the past two years port two went bad so I moved that actuator to port 3 per S.E troubleshooting solution. As of last week port one also stopped working so I moved that actuator to port 4 . I am now on port three and four. Anyone here have these issue? If so how did you resolve the issue. I am out of warranty and it will cost me $400.00 to get a replacement. Hoping someone did a DIY repair. There are two components in the control unit case. The main unit which house the fan and a separate pcb board that the ports are located. Not sure if the issue is with the port pcb or the main control unit. Any input would be great. Thank you!
    Artistichalo, Jun 27, 2020
    #1
  2. hideki

    hideki Active Member

    Joined:
    Feb 3, 2014
    Messages:
    169
    Location:
    Spain
    Balance:
    - 208Coins
    Ratings:
    +52 / 1 / -0
    My Motion Simulator:
    2DOF, SCN5
    Those things happens in some simxperience boxes, Best thing to do is keeping the ports that work and use just the power suply (usually a good reliable Meanwell) and then make new ports with this cheap ftdi controllers such these ones https://www.amazon.com/-/es/Tech-RS...s=rs485+usb+controllers&qid=1595767429&sr=8-3 Simtools will work with both simxperience box and the new controllers at the same time. Just asign the ports like always, Here, there is a thread that could help https://www.xsimulator.net/communit...mexperience-motionrig-to-simtools.5783/page-2. Good Luck
    • Like Like x 1
    hideki, Jul 26, 2020
    #2