1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Snc6 drivers

Discussion in 'Commercial Simulators and Peripherie' started by diab974, Feb 7, 2024.

  1. diab974

    diab974 New Member

    Joined:
    Nov 23, 2023
    Messages:
    3
    Balance:
    12Coins
    Ratings:
    +2 / 0 / -0
    My Motion Simulator:
    SCN6
    Hello everybody,

    I just bought a 3M prosimu a few months ago, and I'm going to buy a new PC soon to run all of this.

    I found out how to configure the actuators on the PC (simtool) but I couldn't find anything regarding the drivers.

    I would like to know if there is a driver for the scn6 actuators.

    Thanks everyone, hoping to get this machine working

    Simon
    Last edited by a moderator: Feb 7, 2024
    diab974, Feb 7, 2024
    #1
  2. hideki

    hideki Active Member

    Joined:
    Feb 3, 2014
    Messages:
    169
    Location:
    Spain
    Balance:
    - 208Coins
    Ratings:
    +52 / 1 / -0
    My Motion Simulator:
    2DOF, SCN5
    Hi, I think you dont need any drivers. If you have the prosimu controller Windows will recognice it just fine. Check what COM port is asigned to each actuator and then configure simtools
    Last edited: Feb 9, 2024
    hideki, Feb 8, 2024
    #2
  3. diab974

    diab974 New Member

    Joined:
    Nov 23, 2023
    Messages:
    3
    Balance:
    12Coins
    Ratings:
    +2 / 0 / -0
    My Motion Simulator:
    SCN6
    Thank you very much.
    No need driver with simtool. All is works.
    • Like Like x 2
    diab974, Feb 25, 2024
    #3