Arduino UNO/Duemilanove 2dof firmware

Hi,
and in which I engage the pin 6 servos.
Sorry for my english.

Hi everyone. When I use the Arduino Nano, which pin do I get involved. For the same as the Arduino UNO ??
Thank you for your response.

Yes, @berty, Arduino Nano has the same pin names as Arduino Uno.

Hi @prilad.
I'm using a bridge equals the trust928 ... there is a need for this door "not " in the output , since I only need two connections ... InA and InB ?

Hi @Alexandre Kostik.
You can't connect bridge with InA and InB inputs directly to arduino with my firmware... Please read this thread starting from
http://www.xsimulator.net/community/threads/arduino-uno-duemilanove-2dof-firmware.4564/#post-45175

@prilad
hi friend,is there any simple DIY solution for isolation(opto.. or galvanic or any...)
thank you
Hooshang

Ok @prilad !!!
would this sequence of calls?

@prilad help me !!! LOL .....I am unable to connect xSimcontrol because accuses the following sentence ... "not enable COM- port . Check COM -port setup" .... go into the setup and click on COM and aprecem doors , being featured in the COM4 ... I click on it and " Error !!! C'ant open port" which appears ... do I hit the setup? thanks

@Alexandre Kostik , try to delete file "xSimCtrl.ini" and then run program. It will help to setup COM-port...
And about signal "sequence" - yes, you can use PWM and IN1 pins from optoisolator as PWM and DIR pins 74ls02

Ok @prilad !!!! Tks!!!!

@prilad !!! ard which code I use ?

See topic. You can use any enabled *.hex file. In first try with *57600*

Ok @prilad !!!
links would look like ?

I'll draw the right schematics tomorrow

Tks @prilad !!!!!

hi prilad,

I would like to try your code, but is compatible with my motor controller card? (Arduino + pololu VNH5019)

Here is the link for the card:
http://www.pololu.com/product/2507

is what I must change the code? (pin)

Here is the link to my post:
http://www.xsimulator.net/community/threads/playseat-2-dof-24v-arduino-pololu-oculus-rift-dk2.6140/

What is the difference with the code I use At the present moment, that of Racing Mat?

thank you for your answer

There was a problem - when active use lost connection with arduino. Helps only disconnecting and reconnecting USB port and restart the utility.

Arduino Uno - Monster Motor Shield - 2 wipers, arduino_uno_by_Ale_v3

Hi @prilad ...
I hope U R doing well my friend ...
pls. have a lock to the attached optical light detector IC datasheet of a regular optical-mouse .

Can an optical-mouse be used as a motion feedback X or Y sensor with the Arduino ?

I'll be dedicated for all the hardware and interfacing testing ... All members opinions and experiences are welcomed too

With my best Regards ...
Speedy

How and where to download firmware?

Как и куда заливать вашу прошивку? переводчик не так перевел