1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Looking into upgrading from Sabertooth/Arduino to Servo Motor Kits w/ Thanos

Discussion in 'Motor actuators and drivers' started by hannibal, Sep 12, 2021.

Page 2 of 2
  1. hannibal

    hannibal Active Member

    Joined:
    Sep 29, 2018
    Messages:
    677
    Balance:
    4,490Coins
    Ratings:
    +297 / 4 / -0
    My Motion Simulator:
    6DOF
    made a video test.
    calibration torque at 20, and max servo speed at 1000

    • Like Like x 1
    • Winner Winner x 1
    hannibal, Nov 8, 2021
    #21
  2. hannibal

    hannibal Active Member

    Joined:
    Sep 29, 2018
    Messages:
    677
    Balance:
    4,490Coins
    Ratings:
    +297 / 4 / -0
    My Motion Simulator:
    6DOF
    i need help with mover & AASD + servo motors... i feel like im not getting a good RPM when i run loops and games in mover... when i use the AMC thanos controller to send rig up and down, i see that the AASD will show around 1500. (note my AASD are set to 3000 as max rotation. but when im running a loop and i did rolls in A10 for DCS via mover flyPT, the most ill see the AASD show is 500....

    trying to see if i can get some help here on the forums..
    hannibal, Nov 17, 2021
    #22
Page 2 of 2