1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Questions about these parts

Discussion in 'DIY Motion Simulator Building Q&A / FAQ' started by mohawk24, Mar 8, 2009.

Page 2 of 2
  1. tronicgr

    tronicgr

    Balance:
    Coins
    Ratings:
    +0 / 0 / -0
    Hi mohawk24

    You cant use high voltage AC motors...

    You need small voltage DC motors 12V or 24V

    Perhaps something like the next one!
    http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 0018496509

    The above actuator is nice! Too bad that he has only one!!! You can see my question there on the shipping cost!!!! :lol:

    The company that sell these is now closed and I could only grab some information from google cache:
    ND-358A: 3.5:1 Helical Gear, 8 rev/inch Acme Screw. Min. Backdrive Load. 600 lbs. 2669 N. Max. No-Load Accel. 25 in/s. 2. 635 mm/s

    And some mode detailed info:
    Motor Type = D = 24VDC, 4.5 Amp, Permanent Magnet Motor
    Drive Ratio = 35 = 3.5:1 Helical Gear
    Screw Type = 8A = 8 Pitch (.125” lead) acme leadscrew
    Stroke Length = 12 inches
    Mounting Styles = MS1 = Side End Angles
    Rod Ends = MT1 = Male Thread
    Speed in/sec [mm/s] = 3.0[76]
    The above data is from here: http://www.danahermotion.com/website/co ... s_User.pdf


    Best Regards, Thanos
    tronicgr, Mar 26, 2009
    #21
  2. mohawk24

    mohawk24 New Member

    Joined:
    Jan 5, 2009
    Messages:
    31
    Balance:
    0Coins
    Ratings:
    +0 / 0 / -0
    mohawk24, Mar 26, 2009
    #22
Page 2 of 2